beaterX project thread

[Murlo26]

I'm not sure what Shane was running for timing on my car but it certainly sounds do-able. I can't really complain about the BBX.



I saw your post discussing fasteners. I'm debating what I'm going to do since I already own the APR splitter. I might ditch it for an undertray and a non-Aero splitter. I'm not going to make a decision until Spring. I'll see what you end up with. :)

With the tubular mani 400whp on pump sounds possible, but it won't be easy. We haven't seen enough setups like this to say for sure though...so who knows.

[mlomker]

With the tubular mani 400whp on pump sounds possible, but it won't be easy.

I'm assuming when he gets S2s in there that they'll outperform my MX1s.

If I end up pulling my motor a year from now then that little error will get corrected. It'll also give me some time to let other people spend their money to figure stuff out. I can't afford to be a trendsetter anymore. heh.

[bananas]

http://i.imgur.com/LbyM3.jpg


http://i.imgur.com/wwClg.jpg

[FattyBoomBatty]

I spy three n00bs. Nice progress again, and as for being a trend setter/first to do something, it's not about the cost and time it takes, it's about knowing you were the first to do it. I love that feeling. :D

Cliff notes: put a carbed v8 in it.

[Halon]

Is that a terrorist? Oh wait wait, it's just Spaz :)

:D I keed I keed.

[scheides]

Lookee what showed up today :)

http://www.scheides.com/albums/evox-buschurfmic/IMG_3569.sized.jpg

http://www.scheides.com/albums/evox-buschurfmic/IMG_3572.sized.jpg

http://www.scheides.com/albums/evox-buschurfmic/IMG_3576.sized.jpg

Stock LICP kinda hangin there but it lines right up and is juuuust shy of 2.5", probably about 2 3/8" OD and flows very nicely:
http://www.scheides.com/albums/evox-buschurfmic/IMG_3583.sized.jpg


Also, found this chunk of lead behind where the FMIC mounts, it seriously must weigh almost 7 pounds. Goodbye! :D
http://www.scheides.com/albums/evox-buschurfmic/IMG_3574.sized.jpg

[Murlo26]

My lead weight is sitting in my garage...wait no, the basement, lol. I think it was there to try to maintain 50/50 weight distribution as best as possible, screw that!

Oh, nice FMIC! Looking sharp :)

[cmspaz]

Is that a terrorist? Oh wait wait, it's just Spaz :)

:D I keed I keed.
LOL!

I was told on another board that we need to stop having Chuck Norris jokes and instead have jokes about things hidden in my beard. :rollinglaugh:

No Shave November is almost done so I'll attempt to improve that situation as soon as it ends.

[mlomker]

found this chunk of lead behind where the FMIC mounts

I'm going to do weight reduction as one of my last projects, so good to know.

[turbotalon1g]

sweet i have this week off work if you need hand sometime, i need to start getting out of the house for winter.