- Need Help with oil return line.
- 1g tranny going into 2g?
- Stock fuel filter?
- oil pressure
- 4g63 n/t head
- Engine knocking
- Measureing Cams...
- interesting find
- timing belt question
- Front Cover - OIL seal installation question
- radiator question
- What comes in a turbo gasket kit?
- Front Cover - Castle Nut Removal/Install
- Smoking
- Stripped turbo bolts
- Removing shifter arms and clutch issue
- how do you install a manual boost controller????????
- 2 fast questions..
- replacing bearings
- Inserts on transmission arms.
- oil cap
- 1st gear hub sleeve
- Rear End And Tcase Fluid
- Clutch Pedal Vibration, warped flywheel?
- Oil pump gears alignment mark question
- Whats the difference? Blow off valves
- Question about 1g AWD auto trans problem
- Bronze or OEM cast guides on a rebuild?
- oil pressure problems
- bumber/oil
- oil pressure light is on
- good transmission shops?
- High Flow Cat, Test Pipe
- is 5 deg BTDC ok?
- Rebuilt S16G on, now smoke/hesitation/no BOV
- Quick question on 2g crank & girdle install
- not hitting full boost
- Clutch to the Floor
- Accel Gen 6 help
- Do you spray your gaskets before putting them on?
- intake hard pipe
- When Timing Belts Go Bad...
- Clutch Pedal Adjustment..
- No wastegate vac line
- 1g bov gasket
- cyclone...?
- .020 over pistons..
- Checking for Crankwalk
- So I'm thinking about a twin turbo setup... Opinions?
- Rebuilding my engine