- Spun rod bearing
- Evo X FPblack vs Fpred and FPblack vs evo8 black
- Hardly any boost
- Where to reference boost with rising rate fpr?
- Thinking about doing a 4g64/4G63 head combo
- Hmm. Properly remove oil feed line without bending?
- ebay o2 housing
- 2G auto trans question
- could this work!?!
- BorgWarner EFR turbos
- Cold plugs, cold weather cold start idle implications
- subaru tranny in dsm????
- So i just did my rod bearings on my stock 7-bolt with 150k on it.....pix
- 1 week turbo went bad after rebuild
- auto to manual
- somethings wrong with the fuel system!
- WTF happened to my plug
- EvoX: How to run Toyota Prius coils in place of stock coils
- inline fuel pump booster
- Anyone know the size of the studs that are on DSM downpipes?
- INJECTOR CONNECTORS
- What is a good clutch?
- Ebay Throttle Bodies, anyone?
- clutch or transmission problem
- exhaust manifold
- How To Tell a TD05 Housing Between a TD06?
- Tap and die, oil feed line.
- direct port nitrous on stock intake manifold
- evolll 16g rebuild
- Take a look at these cams...
- EVO5
- Nitrous and Automatics
- All Sorts of Higher-Flowing fuel pumps coming onto the market
- Found 1.86 ratio fift gear, bigger 3-4 synchros :)
- Evo9 Clutch Install Problems
- Good tech review on evoX transmission
- T3 or mitsu setup
- 90 laser stock high rpm studder
- Leaking freeze plug, and bare wire?
- Intentionally inadequately designed thermostats.
- Am I overlooking something? Low compression
- 4G64 2.4L into 1gb dsm...
- good parts or bad parts
- Putting a hitch on my 1g awd talon
- 4G37 engine swap, out of an auto into a manual
- Owning a 2009+ Ralliart just got a whole lot more interesting...
- BOV Fluttering?
- hx 35
- AEM analog boost gauge not reading right
- Brian Crower 280 cams on the Street?