- 50 trim oil feed restrictor (13 replies)
- super 16g or 20g? (14 replies)
- 90 tranny in a gvr4 (6 replies)
- Questions on whitch rods and pistons to use. (26 replies)
- Tranny Stuck in Gear (7 replies)
- Abs Removal (9 replies)
- Who has it? (5 replies)
- Arp Tool! (11 replies)
- 2g caps on 1g head (5 replies)
- Oil temp and Water temp sensors (0 replies)
- Exhaust/Turbo system install help/??? (5 replies)
- Air Temp Sensor Location (2 replies)
- Apexi Muffler/Can jacked, is it fixable? (2 replies)
- What Stage for Shep Tranny? (14 replies)
- Ignition Problem? (5 replies)
- Changing valve springs with head on the car (6 replies)
- big 16G ??... (16 replies)
- Random No Spark, Starting problem!! (0 replies)
- Help me understand.. (2 replies)
- Possible Head Gasket, Need Second Opinion (8 replies)
- 1st gear help (9 replies)
- Coolant leak!? (1 replies)
- Turbo install (11 replies)
- What can I remove to make my car lighter? (25 replies)
- Any good built longblocks?? (5 replies)
- Bad BOV? (6 replies)
- Bad Master Cylinder? (12 replies)
- Bad vibration at 55mph (3 replies)
- Turbo head on a non-turbo 2.0 (3 replies)
- Oil Leak (7 replies)
- FP3052 just arrived. (6 replies)
- I need 4 bolt rear end cups!! (2 replies)
- GVR4 tranny needs GVR4 axels? (3 replies)
- Looking into a turbo, but whitch housing? (8 replies)
- leaky waste gate actuator (5 replies)
- Mating my 2g Auto w/ 6 bolt block (1 replies)
- boost leak on/around turbo? (4 replies)
- Tranny Swap Help (10 replies)
- BOV Help (13 replies)
- 95 AWD AT quesiton (0 replies)
- evo3 GT *knock off* (14 replies)
- Did a compression test tonight. (17 replies)
- Rear end swap problem (3 replies)
- T-Bolt Clamps (6 replies)
- My Tranny Teardown (24 replies)
- Help getting tranny in (6 replies)
- Manual Boost Controllers INFO (5 replies)
- Radiators (3 replies)
- Turbonetics T3/T4 VS. 20G (8 replies)
- If you buy a PTE Turbo with Internal Gate..... (13 replies)