- 7bolt head vs 6 bolt (8 replies)
- falls flat on the face! (21 replies)
- 2g 4g head on a 1g 4g HELP! (1 replies)
- Intermediate Shaft (9 replies)
- inercooler Q (11 replies)
- rusted to f*ck nuts on fuel pump cover solutions (8 replies)
- Help me decide on cams! (18 replies)
- intake and exhaust mani bolt pitches (3 replies)
- Cyclone Motor Swap (4 replies)
- Different Water Pumps (3 replies)
- 2g o2 housing in a 1g dsm (3 replies)
- weird 3rd gear (15 replies)
- changed the gasket and still have boost leaks (28 replies)
- installing a 1g 4g63 in a 2g? (6 replies)
- Motor Problems?!?! (12 replies)
- 14b swap parts for 2g (4 replies)
- How to seperate AWD CV shaft from intermediate shaft? (7 replies)
- removing the awd system from tranny (42 replies)
- boosting on stock guts (13 replies)
- Where to get a new fuel sending unit? (5 replies)
- Any use for AWD tranny parts? (0 replies)
- Hyundai Valve Cover: Where to get a gasket?! (4 replies)
- Anyone use any Truck intercoolers? (8 replies)
- Xfer case bolt stripped !! (9 replies)
- Well my car took a **** on the road (29 replies)
- Drilling thermostat (67 replies)
- Throw Out Bearings: experiences (2 replies)
- injectors (6 replies)
- aahhh a dsm problem (5 replies)
- To Copper Spray Or Not To Copper Spray (4 replies)
- Setting Up Cam Gears For A 2.4L (28 replies)
- Automatic Transmission (20 replies)
- boost tap (7 replies)
- Dump off of O2 (7 replies)
- 1G Oil Pans (4 replies)
- Help..... Sos!!! (20 replies)
- Oil pan RTV (1 replies)
- Starting rebuilt engine for the 1st time (7 replies)
- About the gt35R (16 replies)
- Nice sounding mufflers (10 replies)
- Water Pump question (17 replies)
- head caps?? (5 replies)
- Defective Release bearing right out of the box (6 replies)
- Tial 38 w/g vacuum line routing (5 replies)
- MBC lines (34 replies)
- VRS Exhaust (2 replies)
- TD05/TD06 7cm turbine housing (3 replies)
- Installing Engine & Tranny questions (6 replies)
- shops for doing head work on a 420a? (0 replies)
- finally made a boost leak tester (3 replies)