My Talon

[Shane@DBPerformance]

Here

[4g63tcrazy]

He said it was at 28psi with 18 peak timing.

[turbotalon1g]

Dat graf is sik yo!

[sleepydsm]

I just thought I'd make this power at a lower boost level, and that spool would be better.

Anyone have any thoughts? BAD boost leak?

[4g63tcrazy]

You didn't boost leak check you're car before the dyno/tune??

[Halon]

I'd check for boost leaks for sure. But you're also on a mitsu exh side right?

[C3L1CA]

Looks like the boost falls off up top a little on that run, maybe thats why you didn't make more horse powa y0. haha

Still some damn good numbers and has got to be a fun car!

[sleepydsm]

You didn't boost leak check you're car before the dyno/tune??

Yes, I did.

Ha, there was kinda a boost leak at what appeared/sounded like the turbo itself. I checked with soapy water, etc. I gave up and called it good.

If it was a bad boost leak, wouldn't we have noticed something on the dyno?

[sleepydsm]

Looks like the boost falls off up top a little on that run, maybe thats why you didn't make more horse powa y0. haha

Still some damn good numbers and has got to be a fun car!

Pretty sure the difference between our setups was turbo choice, and you have a SMIM.

But at like a few pounds less boost, you made more power and torque, and spooled faster.

What gives? Holset ftl?

[asshanson]

I'd say more along the lines of FP and ball bearing FTW.
Still nothing to complain about. I'm on a 2.3 stroker and it took 27psi to make almost exactly those numbers. That isn't bad power for a 2.0 on 27psi, congrats.