View Full Version : My Talon
sleepydsm
05-31-2009, 06:32 PM
Hey Now!!!
Hahahaha. Look at your sig :D
wheelhop
06-01-2009, 07:20 AM
I had a 1/4 tank of e85. I'm about 190lbs., so maybe 3200w/driver?
Seems like my car has no low end and mid range power, it really doesn't launch hard. I think the 2G timing map on the car is too conservative.
Reguardless, I am really happy with what it ran, a lot quicker than I thought.
Wow thats over 500whp with that trap speed and weight. . .
Horsepower from ET (http://www.race-cars.net/calculators/et_calculator.html).
4g63tcrazy
06-01-2009, 01:07 PM
But he's only putting down a hair more than 400.. Hmm
Shane@DBPerformance
06-01-2009, 01:13 PM
Low reading dyno...
4g63tcrazy
06-01-2009, 01:20 PM
True...
wheelhop
06-02-2009, 12:08 AM
Dynos are for tuning, not for dick flopping ;)
ET with an accurate weight equalizes and applies across the board as a fair comparison.
Shane55113
06-02-2009, 03:31 PM
why are you selling your car?
wheelhop
06-04-2009, 06:08 PM
i've done pretty much everything i've ever wanted with a dsm with this car (make over 400awhp on dd, run a decent 1/4 mile, and beat a very intimidating v8 car in a race where i was completely underestimated), and i've owned 1g awd's my entire life. I'm kinda ready for something new. I really like projects, and i actually complete them!
But we will see, because i have really put a ton of time and effort into this car, it really isn't worth selling!
. . . . .
sleepydsm
07-04-2009, 12:58 PM
Got my front wheel bearings, sealls, ball joints, and outer tie rod ends. I should be doing all this front end work on Sunday. I may do a HOW TO write up! haha. I will also be doing rear calipers/rotors/pads before BIR.
sleepydsm
07-07-2009, 01:56 PM
Finally did: New front wheel bearings, in/outter seals, New ball joints, outer tie rod ends, New loaded rear calipers, rear rotors, LF axel seal. Haha, my car is getting better all the time.
vBulletin® v3.8.4, Copyright ©2000-2025, Jelsoft Enterprises Ltd.