My Talon

[sleepydsm]

I picked up my TurboX coated parts from Bob at Map today. I went over to the car and put some of it on. I realized I'm gonna have to cut a lot more off my downpipe than I thought, and I need to chop part of my compressor cover outlet off and weld on a 90 elbow.

The drain is gonna be kinda funky. I might need two 45 degree -10 fittings to get it to work right.

I also need some more 02 housing bolts, I should most likely order new turbo bolts and lock washers from mitsu.

I have to fab up my 4" intake, v band downpipe, a oil drain, install cams and new OFH and oil cooler, and set up Link!

[mike55112]

Hurry up, get this shit done. You and chris are probably gonna be done around the same time. Oh ya, Kara texted me something pretty funny about your ride home last night.

[Swifty1638]

get this done!

-A. Swift

[sleepydsm]

I just finished polishing my compressor cover, for my first time polishing, and how lazy I was, it turned out pretty good. LOL those aren't my candles either.

I also got my lower intercooler pipe set up for the Holset, and re powdercoated at Primo.

Should be getting my pushlock drain tube any day (I hope!)

And so I just need to spend some time with the car and get it all buttoned up!

[Halon]

Sweet!

[4g63tcrazy]

Wow.. That looks really good! Better than I did with my 16g..

[sleepydsm]

Cams are in. Just need my oil drain so I can spend the 30 mins bolting the turbo and o2 up.

Chop flange off downpipe, TIG vband on, thats pretty much it.

[mx3twinturbo]

Kevin,
I know those candles are yours!
looking good man,

[sleepydsm]

Ok, so whenever the hell it warms up a bit, (tomorrow/sunday) I'm gonna go put my o2 housing/wastegate on, and hopefully start my downpipe modding. I also need to tighten a few fittings on my oil filter housing. Pics soon.

[sleepydsm]

Rad in, drain tube made, downpipe is hopefully gonna be welded today. Just need to hook up a gauge, clutch wire and maybe wideband for Link, and setup Link. :) Ooo and drain my tank lol.