PDA

View Full Version : SE take two! Err, make that three!

Pages : 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 [31] 32 33 34 35 36 37 38 39
Kracka
03-14-2013, 08:03 AM
New flywheel and clutch are mounted...

http://www.mitsustyle.com/photopost/data/547/medium/IMAG0273.jpg
rose0529
03-14-2013, 08:37 AM
Yay!
Kracka
03-24-2013, 02:01 PM
Woohoo! Running and dyno-tuned, very productive weekend! A few minor issues this weekend but nothing serious (o2 sensor, dipstick, and LICP coupler). The tune is done though and she runs/drives/idles incredibly smooth. Calvin @ Cobb does want to do a check-up on the tune and an alignment before the cruise, after the engine gets a few more miles on it (only 115 miles when we dropped it off yesterday).

I'll let Andrew post his results and chart :)
evotuner
03-24-2013, 11:10 PM
Yes!! I want to see results i'm going to go search evom haha
Kracka
03-25-2013, 08:10 AM
With Andrew's permission, here you go!

http://www.mitsustyle.com/photopost/data/547/medium/IMAG0295.jpg

http://www.mitsustyle.com/photopost/data/547/medium/IMAG0296.jpg

http://www.mitsustyle.com/photopost/data/547/medium/IMAG0297.jpg
link to larger version: http://www.dsmstyle.com/photopost/data/547/IMAG0297.jpg
453whp/390wtq @ 27.7 psig

Keep in mind that this engine is still tight with only 115 miles on it when it was dropped off for tuning. We were battling boost leak and couplers popping off all day with a poor fitting LICP and by the end of the day the fuel pump and fuel were beginning to over-heat so we called it a day. Once the engine gets a few more miles on it to loosen up and a properly fitting LICP is installed it will be back on the dyno for a few final runs and adjustments (April 13th, the weekend before the cruise). I expect the end results to sit somewhere closer to the 470whp range once it's able to take a touch more boost and timing, and probably rev out a bit further. It is tuned on Tephra V7 with multiple fail-safes and 91-octane map-switching setup, along with gear based direct boost control. The EF4 has MAP's "25 psig" HP WGA, but I have it just barely pre-tensioned so WGA pressure sits around 17-19 psig, with his 91-octane "safe" map sitting in the low-20's. If a high knock count is ever observed boost will immediately drop to spring pressure. I do love that rock solid boost curve!
scheides
03-25-2013, 08:46 AM
So legit! Hella pump gas setup that's for sure. I'm glad all the v7 stuff is being fully utilized, I forgot about all of those little details tephra added.

This is a solid 420 on Shane's dyno. Hella legit.
Tachyon
03-25-2013, 09:02 AM
Nice fat powerband. LOVE IT!

Looking forward to seeing it in action on the MSSC :)
Kracka
03-25-2013, 09:21 AM
The powerband feels awesome, with the longer gearing it goes on forever!
Tachyon
03-25-2013, 09:53 AM
The powerband feels awesome, with the longer gearing it goes on forever!

Ahh that's right, he has the stock gearing with a 4.10 (4.11?) Final Drive?
Murlo26
03-25-2013, 09:54 AM
I think its the HKS 4.11 if I remember right.

Great looking setup Andrew, can't wait to see it on the cruise!