GheyrodX - bigger, fatter, gheyer!

[Kracka]

I wish Mitsu would have just done an integrated antenna into the rear glass like Subaru does.

[mlomker]

I wish Mitsu would have just done an integrated antenna into the rear glass like Subaru does.

They built the Sirius antenna into the base...I'd imagine that has something to do with their thinking.

[scheides]

I just remove mine if I go through a non-touchless carwash. It takes 5 seconds to hop out of the car, unscrew it, and listen to a cd while I'm in the wash :P

[mlomker]

It takes 5 seconds to hop out of the car, unscrew it, and listen to a cd while I'm in the wash :P

You underestimate how forgetful I can be. lol.

[Kracka]

I backed the car up onto ramps yesterday after work so I could install the Beatrush rear diff bushings and Torque Solutions driveshaft bushings...one problem, the rear diff is leaking fluid :( Rather than touch anything I decided it would be smart to just bring it in for inspection before anything else which I did today. Luckily they have the seal in stock and said it should only take a few hours. Remaining optimistic, at least the break-in fluid will be drained and I'll get fresh stuff! I'm bringing the car back Tuesday morning for them to replace the seal and redo the alignment (both under warranty).

I think I'll go outside now though and install my WORKS shifter bushings and Perrin turbo inlet tube :)

[Kracka]

Today I got the Perrin turbo inlet tube, AMS shifter gate pivot bushing, and half the WORKS shifter cable bushings installed. I pulled a newb and dropped the other shifter bushing into the engine bay abyss and haven't been able to find it yet :( It definitely shifts nicer already so I'm excited to get the other shifter bushing installed; I emailed WORKS to see if they have a spare they could send me. Can't say I felt a big different from the inlet pipe, but it does seem a bit louder. I was going to install the Perrin drop-in air filter too but the foam is ultra thick unlike their open element filters; it was almost 2" thick which seems crazy to me! I will just retain my stock paper filter until I install the AFE intake (going to do that right before I get tuned since it can throw AFR's off a little bit).

[Kracka]

I was out riding my bike today and I found the bushing laying in the middle of the road on the other side of my neighborhood!

[TkrPerformance]

you got lucky and found it.

[Kracka]

you got lucky and found it.
No kidding! I considered it good as gone.

[polishmafia]

LOL! That is some good luck.