View Full Version : GsXtUrBo98's 2G project thread
Halon
06-05-2011, 09:49 PM
Do you have a link to this video from Jack's about adjusting the clutch?
GsXtUrBo98
06-05-2011, 10:09 PM
http://www.youtube.com/watch?v=vYJxQyjIhUw
GsXtUrBo98
06-05-2011, 10:35 PM
Well after doing some research I might have a bad master cylinder... I will call shep tomorrow and see what he thinks. Until then the car is going to sit where it is. Out of site out of mind.. Until I call tomorrow ofcourse :)
CornFed2.4
06-05-2011, 11:01 PM
Well my phone died, but I seen you called again. Last year at Brainerd my car was doing the same thing. No matter the adjustment bleeding whatever, it would move forward when I bounced off the 2-step. I just held the e-brake at the light. If you figure it out lmk for sure. I think mine eventually fixed itself but I also had the tranny out 3 times in 2 months after Brainerd.
GsXtUrBo98
06-07-2011, 07:12 AM
Well I started my new job yesturday and didnt have a chance to call shep so I just sent Jacks a email asking what he thought and am waiting for a response. Last fall I did a launch and when doing so the clutch felt like it was engaging at the floor so I parked it thinking the clutch was toast. When I replaced the clutch I then found out that I had a hole in my clutch line from wearing down on a moving part. SO, I bought a ss braided line for it an put it all together just to find out that its still doing the same thing?? EVERYTHING IS NEW except the master cylinder... New slave with extended slave rod, cutch line from master to slave, clutch, pp, everything except master.
Anyways, I was wondering if anyone else thinks it could be my master cylinder? Any input would be great.
scheides
06-07-2011, 07:44 AM
Or a bent clutch fork? Did it look bent when you put the clutch in?
DSMINMN
06-07-2011, 10:00 AM
Damn... Just went through your thread. Looks like a pretty sick build sir. Now I understand why you said "Hey! There's nothing wrong with a 2gb red eclipse.", lol.
GsXtUrBo98
06-07-2011, 10:07 AM
Or a bent clutch fork? Did it look bent when you put the clutch in?
Clutch fork looked to be good when installed.
95talonracer
06-07-2011, 11:54 AM
I ran a billet clutch fork and had no issues.
GsXtUrBo98
06-07-2011, 12:15 PM
I talked to shep and he said for sure next step is get a new master cylinder then if its still doing it I might have a faulty pp...
vBulletin® v3.8.4, Copyright ©2000-2025, Jelsoft Enterprises Ltd.