PDA

View Full Version : GsXtUrBo98's 2G project thread

Pages : 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 [19] 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41
GsXtUrBo98
05-17-2011, 08:46 PM
some pictures
GsXtUrBo98
05-17-2011, 08:52 PM
Some more pictures
95talonracer
05-17-2011, 09:20 PM
I'll Go take some quick and get back to you. Also, I'm not the only one that had problems with this kit. Nick (cornfed2.4) has the same kit as me and had trouble with it.
Yea. you are better off customizing the piping to fit exactly to your setup with clearing things like DP, radiator and or fans, turbo, intake, ect. Looking good. whens it going to be on the road.
GsXtUrBo98
05-17-2011, 09:53 PM
^ first things start up. Then I will button things up and make them look better, I could have this thing on the road next week. BUT, I need to get at least 2 to 3 more things befoe tuning it. BAP,A1's, and make my exhaust. I am going to use the downpipe that I have on there and then cut the one that I had on there before and weld it to fit the downpipe.. I like everything about thermal exhaust better then the one that I was going to use.
95talonracer
05-17-2011, 10:10 PM
I have a BAP
scheides
05-17-2011, 10:19 PM
Looks good man, keep going!
GsXtUrBo98
05-18-2011, 10:49 AM
I have a BAP

I know this
GsXtUrBo98
05-31-2011, 11:18 PM
Ok so I went to MAP today after work to pick up my second fan that had just came in. When I got home I took my 1g n/a throttle body off and went up to Primo and had Jesse make me a block off plate. I then went to ACE to pick up some new hardware for the block off plate.

When I got home I began putting this stuff on my car. I used some gray RTV for the block off plate and I'm going to let it sit snug over night then tighten it the rest of the way tomorrow. Got both fans wired up and put on my radiator along with the radiator installed in my car, then I hooked up my LICP. Put the throttle body on the SMIM and I am done for the night. I have tomorrow off and if all goes well this thing will be ready to start!

On a side note I picked up some H11's today and am picking up a Boost a Pump tomorrow! not much farther now!
Shane@DBPerformance
05-31-2011, 11:33 PM
What are you making block off plate for? It's going to suck to drive if you totally get rid of the idle motor.
GsXtUrBo98
05-31-2011, 11:35 PM
^This is what everyone has told me to do.. I will not be driving this all the time and will not drive this at all in winter so I deleted the FIAV