GsXtUrBo98's 2G project thread

[GsXtUrBo98]

I got the new master cylinder today and installed it, then bled the clutch/slave and adjusted the clutch. I WORKS! it no longer ingages at the floor! it does however slightly move when the clutch is in and I rev it up but not bad at all.

On a side note I took it for a drive and the steering wheel shakes and when I turn right I hear a grinding noise.... This is just depressing

[b00sted_spyder]

Your wheels might need to be balanced if the steering wheel shakes.

[GsXtUrBo98]

^ yes I thought this but I'm not too sure as to what the grinding noise is..

[GsXtUrBo98]

After I got my clutch adjusted I reved it up to see if it would drag and my 2 step went off, after this my car only idles at 2200 rpm's... I am going to get the by pass plate ordered tomorrow and put my idle sensor back on.. you guys win

[95talonracer]

:)

[GsXtUrBo98]

I ordered some plug wires, vacum block, and the bypass plate for my throttle body today

[GsXtUrBo98]

I took it for a drive and the steering wheel shakes and when I turn right I hear a grinding noise.... This is just depressing

Might help to make sure the front 2 tires are tight.... FAIL anyways I snugged them up an were good to go! I got the front bumper trimmed up and installed yesturday and the car is fully driveable now but need to install some more parts. As stated I ordered some more parts but have my head studs to do and rewire of the fuel pump and hook up the bap. Got to have primo weld up my exhaust and make a dump tube aswell. After all is done I need to put insurance on it and get tabs. Finding more ways to spend money on this thing..

[95talonracer]

Tell us you are recirculating the wg back into the exhaust...

[GsXtUrBo98]

Not at the moment.. I will though eventually

[95talonracer]

Nice. So up and running this weekend?