PDA

View Full Version : Swifty's never-ending project thread!

Pages : 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 [59] 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94
LingLing
05-04-2010, 08:24 PM
Nice! Do it up dude! I'll try my best to make it up there with ya.
A//// Guy
05-05-2010, 08:47 AM
Oh snap, doo et.
goodhart
05-05-2010, 08:53 AM
Nice dude! What numbers ya hoping for?
Kracka
05-05-2010, 08:57 AM
I also tentatively set up a dyno date with Shane..May 20th, 2pm.
Nice! Remove that tentative and get it done :D
A//// Guy
05-05-2010, 08:57 AM
100whp till 5.8k, then 600whp for 1k and then rev issues at about 6.9k. :) haha jk swifty.
mlomker
05-05-2010, 08:58 AM
100whp till 5.8k, then 600whp for 1k and then rev issues at about 6.9k. :) haha jk swifty.

Ouch, where's the fire extinguisher?
cmspaz
05-05-2010, 09:04 AM
Ouch, where's the fire extinguisher?
What fire extinguisher?
Kracka
05-05-2010, 09:05 AM
Ouch, where's the fire extinguisher?
Huh?
Matt D.
05-05-2010, 09:06 AM
What fire extinguisher?
Huh?
Swifty just got burned.
Swifty1638
05-09-2010, 05:08 PM
lol, yea. I was hoping to get in before then, but Shane's a busy mo-faoucka!! So, I await.

I cleaned/organized the garage, and took the talon out to fill up with some new gas. So far, so good! no leaks of any, besides a few drops of tranny fluid-I believe it needs new washers for the drain/fill plugs, but I also will replace the shaft seals for the t-case and such for peace of mind, and because I work on my own shit, so labor is cheap ;)