PDA

View Full Version : Swifty's never-ending project thread!


Pages : 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 [29] 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94

Swifty1638
02-19-2010, 10:15 AM
Turbo is patiently sitting on the floor in my room..

scheides
02-19-2010, 10:17 AM
what's the point of doing twin-scroll and then doing a single WGA? There goes part of your powerband man! :D

Swifty1638
02-19-2010, 10:25 AM
there will be 2 tubes coming off the collector, then merging for a wg, farther away..it will still be fine.

slowbubblecar
02-19-2010, 10:57 AM
lol, yea. The alt was grounded, it was a different wire that wasn't that I didn't know about. It was tucked down away from back when hort had the car. Either way, we all find things that are hacked and not the way it should be, and we fix it, right?

The battery relocation done in your car was done by QPR and all parts were from summit. I ordered all of them. The car did not have any known electrical issues before you got it. The electrical system functioned perfectly before the motor was pulled.

Swifty1638
02-26-2010, 01:19 PM
http://hphotos-snc3.fbcdn.net/hs447.snc3/25658_505986843108_195700371_30114050_514708_n.jpg

1-4 runners welded. 2-3 are getting redone since there wasn't a ton of room to run the exhaust. Then, comes the 2 WG's..

LingLing
02-26-2010, 01:21 PM
So sexy! You gonna get it coated?

Swifty1638
02-26-2010, 01:24 PM
I will eventually, I'm sure. I should, as that's a ton of heat. But, Depends on how much it costs, and the fact that money as it is is tight as fuck. I am still suprised I'm making this setup a reality to tell you the truth. Woulda been easier to keep my old shit, and get the billet 6765, but I made it happen I guess!! Gaskets, fuel fittings, figure out the downpipe, and lower ic pipe, oil return, and such..I'll be set!

turbotalon1g
02-26-2010, 01:24 PM
Will this be done before I get home? (may4th-ish)

Swifty1638
02-26-2010, 01:26 PM
I certainly hope it's done before April, so I can get tuned!

scheides
02-26-2010, 01:27 PM
Yes, most tuning shops close their door on April 1 so better be done by then or it'll never get done ;)