My Winter Upgrades

[turbotalon1g]

Nice one. The end is near!!

[Halon]

Just got the car back yesterday. Lil Brown did a good job on the install, and also let me know of a couple little issues he took care of as well. I think he did a great job. This tranny shifts way better then the old one.

This is the first car I've ever been in with one of the new Fidanza clutches also. I have the 4.3 one. I was expecting it to be very grabby, which would make it a lot more difficult to drive, and very jerky. It is a bit more grabby then my old X-Clutch, but really not bad at all. So far I'm very impressed with the drivability of the clutch.

Now I just need to get some pieces painted.

[Halon]

Some more small updates.

The front bumper and the side trim piece that many have seen fell off my car awhile back, were both dropped off yesterday for painting at none other then Osseo's Maaco. They should be ready for me tomorrow.

I removed my TB and Kevbo is rebuilding it better then I did.

Also removed my compressor cover and brought it in to MAP. Kyle welded a 2.5" elbow onto it for me so I could ditch the 90* coupler and the hump hose couplers I was using. The welds look great, I'm real happy with it. This is going to make the lower IC pipe assembly fit a lot better then it used to. I had everything tightened as much as I could before, but was popping the couplers on the lower IC pipe off right at around 30psi. So getting the lower IC pipe to fit better was high on my priority list. I ended up just using about 8" of that diesel radiator hose that is often used as couplers, between the elbow and the lower IC pipe. It is a bit long, but I like it because it would have been hard to lengthen that pipe and still be able to get it down there easily.

Anyhow, that's it for now. If I get ahold of a camera I'll take some updated pics.

[craig]

sounds good now to get some numbers on it

[Halon]

I'm signed up for the Mitsu Cookout Dyno Day on Saturday. I guess we'll see how it does then. It won't be professionally tuned or anything, just tuned by little ol' me. Hoping to be somewhere around 30-35psi.

[turbotalon1g]

Sick i hope 35psi+.

Hopefully he put beads on those pipes.

[Halon]

All the piping is the same, just a new elbow on the the turbo is replacing 1 of the old pipes/bends, and the cast elbows come with a lip on them.

[A//// Guy]

Cant wait for the results!

[scheides]

Woot! Get that thing on the rollers, excited to see what it does? I may just have to venture out for this....

[throwedgsx]

I'm anxious to see numbers. I've been considering switching out my gt3076r for a BW s300 or the s362