the evo 3 swap parts are coming

[eclipse_spyder]

Looks like you will need extended wheel studs to have the spacers fit.

[TkrPerformance]

as it is right now it was all for mock up sense I can get the spacers from craig and bring them back when I am done. I am going to get H&R 15mm spacers with the evo center ring and they come with the extended studs.

[Kevin 1G Drummer]

Awesome! My front brakes are making a little noise... ;) ;) haha

[TkrPerformance]

lol. will have to see if your rims will fit also. we tryed craigs last night and it would need more spacer for his

[eclipse_spyder]

My brembo's fit fine with H&R 15mm spacers and extended studs although my brembo's are not the Evo VIII's. My wheels were 18x7+42 offset

[TkrPerformance]

but the evo 1-3 and 1g knuckles are not even close to 2g knuckles. I will be putting the evo 8 brembos on my spyder also. All evo brembos 5-9 are the same caliper.

[TkrPerformance]

some new up dates on the car. Last week I went to the junk yard for parts for the wifes 1g that I did not have. I ended up picking up a mazda washer bottle with the motor in it so I can hook up my fmic sprayers. I just have to order a alky/meth injection boost pressuare switch for it.
http://i122.photobucket.com/albums/o280/tkrperformance/evo/DSC03793.jpg

Also got tired of the red gas door on the car sense it was the only thing that was red so I shot some primer on it and it looks a lot better now.
http://i122.photobucket.com/albums/o280/tkrperformance/evo/DSC03794.jpg

Other parts that will be here thus this week
the smim was sent 3 day air from japan for ems pricing
the 1/2 front wheel spacers from H&R with the extend wheel studs
3 auto meter roll cage mount cups for the greddy gauges.
Also picking up a set of tire from a buddy for 150.00 they are 215/35/18 Falken 452's with a few hundred miles on them

[Kevin 1G Drummer]

Then all you have to do is press in the 1g rear hubs, right? Oh, and good luck if you hit a pothole ;)

[TkrPerformance]

I have to press in the evo 8 rear hubs make the bracket for the brembo for the back.
Ya I know the tires are small but it is all I can do to get the 18*8's in there. I still dont know if they will fit the rear yet

[TkrPerformance]

the H&R wheel spacers showed up today for the fronts
http://i122.photobucket.com/albums/o280/tkrperformance/evo/DSC03795.jpg
stock 1g stud next to the H&R stud
http://i122.photobucket.com/albums/o280/tkrperformance/evo/DSC03796.jpg