PDA

View Full Version : 1g 6 bolt 4g63 tsi build

Pages : 1 2 3 [4] 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22
dsmghost
04-22-2012, 06:44 PM
Apexi Exhaust pics. Full 3" with 2.5" down pipe
dsmghost
04-22-2012, 06:47 PM
Ebay FMIC w/2.5" piping
C3L1CA
04-23-2012, 07:58 AM
Nice progress, motor looks good! Keep it up!
dsmghost
04-27-2012, 06:52 PM
Nice progress, motor looks good! Keep it up!

Thanks!
dsmghost
04-27-2012, 06:57 PM
Bought this 1gb bumper today, didnt take long to cut it up for the FMIC install (thanks to an oxy-acetylene torch).
dsmghost
04-28-2012, 08:24 PM
Installed FMIC, took some pics with the hood and bumper on. Going to be buying the clutch soon.
dsm_talontsi
04-28-2012, 08:31 PM
Looking great! Made a lot of progress. Can't wait to get the clutch and get that motor in.
dsmghost
04-29-2012, 03:36 PM
I dont know how long this thing has been sitting, Ill be bringing these parts to work so I can resurface the rotors, press in new lower ball joints, and press in new front wheel bearings. The ball joints both had a lot of play, and the bearings felt very rough.
goodhart
04-29-2012, 04:03 PM
The rotors should be fine, they have probably 5k miles at most on pads and rotors on all 4 corners. As soon as you step on the brakes the rusty film will get knocked off them.
evotuner
04-29-2012, 06:50 PM
Good looking build man, i sure hope you have something else supporting the car other than the floor jack like in the above picture...i'd hate to see a car come down and sqaush a mofo