Log in

View Full Version : 1g 6 bolt 4g63 tsi build

Pages : 1 2 3 4 5 6 7 8 9 10 [11] 12 13 14 15 16 17 18 19 20 21 22
goodhart
09-05-2012, 11:47 PM
Yep, get the solid ones for evos, they fit dsms too and are a good upgrade.
scheides
09-06-2012, 12:01 PM
Not the carrier bearings but the actual mounts that connect the chassis to the strap thats on the carrier bearings. Nice improvement when done with rear diff mount bushings as well.

Eff this car is looking good!
dsmghost
09-06-2012, 07:16 PM
Not the carrier bearings but the actual mounts that connect the chassis to the strap thats on the carrier bearings. Nice improvement when done with rear diff mount bushings as well.

Eff this car is looking good!

Ill do both the carrier bearings, all the u-joints, and the strap to chassis mounts. This sloppy rear diff is pissing me off, tons of gear backlash and howls on decel.
dsmghost
09-10-2012, 02:47 PM
I installed a deck I had laying around, I also chopped the stock antenna off and installed this powered amplified antenna on the interior. I got it at Orielly's for $18. It looks way better without the long stock antenna, and works great too.
dsmghost
09-13-2012, 06:08 PM
So today I hit the 1000 mile mark since initial assembly of the Talon, I changed the oil and installed new Bosch Evolution wiper blades. I even got a new one for the rear. Looks like I need a car wash again. I'm also throwing in another pic of the new antenna.
dsm_talontsi
09-13-2012, 06:11 PM
NICE!
dsmghost
09-13-2012, 06:22 PM
Yeah they are nice blades, some places charge over $25 per blade. I got them for about $8 each.
dsmghost
09-29-2012, 07:28 PM
Installed the speed density setup, I still need to hide the wiring, and mount the MAP securely to the firewall. Pushit2.0 did a great job welding on the IAT bung for me. With SD the car runs better than it did with the 2g mas. Having another member do some street tuning for me next week.

Also going to be installing my electronic boost control solenoid soon, been pretty lazy though.
Alpha D
09-29-2012, 08:28 PM
Just found this picture, it was a couple weeks ago when I put in a new LF output shaft seal and new transfer case seals.

Reckless DSM'er no jack stands !? Anywhoos getting work done good job!
dsmghost
09-29-2012, 09:04 PM
Reckless DSM'er no jack stands !? Anywhoos getting work done good job!

haha yup, I used to have a set of 4. oh well