Swifty's never-ending project thread!

Swifty1638 · 04-28-2010

For the last goddamn time. I did not reuse my fucking gasket. I got a cometic HP, but drilled out 3 of the 4 rivets, coppersprayed all 4 parts, let sit overnight, then re-assembled, put back on the car, then slapped the head on, only to need to lift it off a bit to get the washers on..THAT's where I went wrong. If I get nothing but people finger pointing, then I won't ever update this thread again, and you all can go read some other shit. No skin off my ass. Shit happens sometimes, oh well! It will be fixed when I can fix it. Big fucking deal.

**Kracka** · 04-28-2010

Quote:

Originally Posted by Swifty1638

drilled out 3 of the 4 rivets, coppersprayed all 4 parts

Why? I'd be willing to bet that has the potential to cause more issues than prevent any.

tpunx99GSX · 04-28-2010

Quote:

Originally Posted by Swifty1638

For the last goddamn time. I did not reuse my fucking gasket. I got a cometic HP, but drilled out 3 of the 4 rivets, coppersprayed all 4 parts, let sit overnight, then re-assembled, put back on the car, then slapped the head on, only to need to lift it off a bit to get the washers on..THAT's where I went wrong. If I get nothing but people finger pointing, then I won't ever update this thread again, and you all can go read some other shit. No skin off my ass. Shit happens sometimes, oh well! It will be fixed when I can fix it. Big fucking deal.

Its ok swifty. I do recall the conversation but it was more of a pondering as to whether to reuse or not to. which he came to the conclusion that he would not be reusing. I am reusing mine, and i will post up the compression tester results and we can compare. But i have always reused my metal head gaskets, never taken out the rivets though that seems pretty extreme. Maybe next time ring the block and head and not have to worry about expensive head gaskets.
Speaking of which have you done a compression test?

**Kracka** · 04-28-2010

Quote:

Originally Posted by tpunx99GSX

I am reusing mine

This thread is full of fail. I don't see the point to trying to be a cheapass and save a few bucks when it risks having the rip the head off again, buy a new gasket anyway, plus all the additional stress, headache, and downtime.

blackrosenova400 · 04-28-2010

Plus headstuds, or any studs for that matter dont like to be stretched 50 times...

Quote:

Originally Posted by Kracka

This thread is full of fail. I don't see the point to trying to be a cheapass and save a few bucks when it risks having the rip the head off again, buy a new gasket anyway, plus all the additional stress, headache, and downtime.

Matt D. · 04-28-2010

Quote:

Originally Posted by tpunx99GSX

Its ok swifty. I do recall the conversation but it was more of a pondering as to whether to reuse or not to. which he came to the conclusion that he would not be reusing. I am reusing mine, and i will post up the compression tester results and we can compare. But i have always reused my metal head gaskets, never taken out the rivets though that seems pretty extreme. Maybe next time ring the block and head and not have to worry about expensive head gaskets.
Speaking of which have you done a compression test?

I just palmed face so hard I am now bleeding and partially blind. You have got to be joking. Please tell me you are.

Compression test isn't going to prove jack shit unless you absolutely fucked up the head installation or the gasket is severely messed up. When the cylinder fires it puts more pressure on the head gasket than just cranking the engine over will ever do.