MitsuStyle MitsuStyle

Go Back   MitsuStyle > Tech > Turbo / Engine / Drivetrain

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 06-15-2006   #7
Shane@DBPerformance
formerly ecoli
 
Shane@DBPerformance's Avatar
 

Join Date: Oct 2003
Location: On the dyno
Posts: 4,892
Send a message via AIM to Shane@DBPerformance
Re: Where do I go from here?

The only way you are going to get 500whp out of 550cc injectors is if you have 6+ of them, methanol injection or a nitrous wet kit. A 16G won't make anywhere near that HP anyways either, without a lot of nitrous. I maxed a set of 680cc fuel injectors on a DSM a couple weeks ago on pump gas. It was putting down a little over 400awhp(normal Dyno Dynamics numbers) at 19 psi, they would have supported a fair amount more power on race gas, but you have to run these motors pretty rich on pump gas to keep from knocking.

You don't absolutely have to get a fancy FPR, if you put a fuel pump in that overruns the regulator. It is nice, but you can usually tune around any overrun problems with a decent tuning system.
__________________
www.dbptuning.com
Shane@DBPerformance is offline   Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 09:39 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.