Mark's Evo IX MR Winter Projects

[Mark Leasure]

I'm sticking with low compression, works on my 1G. It’s going to be an identical lower end, except 6 bolt vs 7 bolt. I already have pistons for my build too. It becomes more important to build in detonation margin in the system since I’m using an AEM that lacks and suffers from the ability to react to knock like the factory ECU. The AEM has an insufficient level of knock control algorithms that the stock ECU has. Spool is important but I’m not willing to sell my soul, a good reliable 700WHP setup is what I’m trying to build.

[turbotalon1g]

I can't wait to see this in action.

[Mark Leasure]

This afternoon I milled up a fixture for my upcoming manifold fabrication project. I’m doing a top mount v-band manifold for a BB 6266. It bolts down the head flange to reduce warping when I finish weld everything together. I also included a port on each runner for back purging. I also built a jig to cut SS pipes at precise angles to fabricate a v-band merge collector.

http://i412.photobucket.com/albums/pp207/Wicked_EE/IMG_20111203_165001.jpg


http://i412.photobucket.com/albums/pp207/Wicked_EE/IMG_20111203_165013.jpg

[daneatsv8s]

Nice work Mark.

[Pushit2.0]

http://www.solarflux.com/Pages/Productinfo.html

For SS welding I used this, its a powder you mix with methanol and put on the back side of each weld with a little brush. You mix it to a not to think, not to thin paste and after your parts are all mocked up I mark and break it all down to put the flux in.

It leaves a black glassy backing where the weld is, then wash out your pipes when you are done. Looking good, this should move out when your done.

[Mark Leasure]

Quick update: I fab’d up my merge collector this weekend. I’m still waiting on the v-band to finish it up. I plan on assembling my engine next week. I’m still waiting for the transfer case to come back from jacks before I can get the engine back in the car. I have a couple of weeks off at the end of the month and I plan on wrapping up the motor/trans/t case installation, with a stretch goal of finishing my manifold fabrication then too!!
I bought one of those gas saver lenses and another argon regulator for back purging. I haven’t welded much stainless in the past so for a first try I think it turned out awesome.
http://i412.photobucket.com/albums/pp207/Wicked_EE/IMG_20111211_095613.jpg

http://i412.photobucket.com/albums/pp207/Wicked_EE/IMG_20111211_094308.jpg

http://i412.photobucket.com/albums/pp207/Wicked_EE/IMG_20111211_090226.jpg

[scheides]

Not bad for a newb! :P

Very nice man.

[TalonFiero]

Nice work Mark!

I'll have to find time to make my way over to your place and check out the work first hand. :)

I need some motivation!

[At-Least-It's-An-Evo]

Nice work Mark!

I'll have to find time to make my way over to your place and check out the work first hand. :)

I need some motivation!

Very nice! Jim, pick me up on the way, i wanna see this cool shiat too :)

[turbotalon1g]

I'd like to take seat no. 3