PDA

View Full Version : 1994 Talon TSi

Pages : 1 2 3 4 5 6 7 8 9 10 11 12 [13] 14 15 16 17 18 19 20 21
C3L1CA
03-11-2010, 03:30 PM
I would think there would be a how to on it, so you know for sure. Brakes are definitely something I would want to be 100% sure on.

If you can't find it maybe I can find my service manual cd and see if it shows in there.
goodhart
03-11-2010, 09:31 PM
I think I will go to DB tommorow to look at Mara's 1g and draw myself a little diagram so I know where they go. Also to see how the 90 OFH and external oil filter housing is plumbed so I can hook up the one I picked up today.
goodhart
03-13-2010, 02:44 PM
Got the non-ABS brake lines I needed, so I will be putting those on later today probably. Now I just need the two banjo bolts that attach the 90 OFH to the 90 oil cooler, so I can install that.
95tsi
03-13-2010, 09:30 PM
Good work dude! Any word on the block yet?
goodhart
03-14-2010, 10:49 AM
John was gonna start on it on Friday. Probably another week.
goodhart
03-19-2010, 10:24 AM
Small Update. John Gosh called me yesterday with an update, he had my engine all apart, discovered that it has already been punched .020 over. This ruled out a bore since I don't want to buy new pistons, I told him to just hone it and re-ring it. We will see how that goes, and if it improves compression compared to before. I also had him put new ACL Race bearings in it also.
goodhart
03-22-2010, 08:29 AM
Well apparently Mahle pistons use special rings, and the nearest set is in North Carolina. Sooo, I am still waiting to get my engine back because of the rings.
turbotalon1g
03-22-2010, 06:58 PM
Mahle for the lose apparantly.
goodhart
03-28-2010, 08:12 PM
Got my engine and head back on Saturday. Got the engine on the stand and got a couple things put back onto the engine, I am still waiting for gaskets to finish it up. Once that is all assembled, I will be mounting the battery, finishing up the brake lines, and putting the motor back in the car. This next week I will most likely be ordering a TRE stage 3.0, and a Comp Stage 4 clutch and a boost-a-pump. I will be bringing the car to Primo to have them fab up an o2 housing, EWG dump tube and intercooler pipes for me, then I will wire up my gauges and I should be good to go. Still shooting for the Dyno day to be my deadline for finishing this project up. Then hopefully I can leave it alone for about a good year or so. lol
turbotalon1g
03-28-2010, 09:47 PM
Good luck thats a ton of stuff.