Evo X upgrades

[scheides]

Originally Posted by mlomker

Would def appreciate that. The only one that I'm aware of screws into the valve cover (passenger front of it). Unless that Boomba can has a built-in check valve then the intake is probably pressurizing the can right now. I need to check that the next time I'm at DB.

The Kracka vents install inline on one of the hoses? I haven't ordered them yet...want to figure out what I'm going to do first.

Yup you'd just put the Kracka Vents between the catch can and IM, to keep pressure in the IM but allow vacuum to suck air from the crank case/valve cover. Talk to kracka before ordering, I bet he can get you them direct at a good price

Checking on the boomba can would be easy, just pull both of the hoses and blow through the one going to the IM. If you can feel *any* air coming out of the VC side, there's no checkvalve in there, and that's bad. The stock PCV can do some, but a beefier setup is def nicer.

[mlomker]

Originally Posted by scheides

Talk to kracka before ordering, I bet he can get you them direct at a good price

I have exchanged a couple PMs with him. I decided to go with another brand since I found some shiny, bling ones. I found some pictures of how they get installed and that couldn't be easier.

Checking on the boomba can would be easy, just pull both of the hoses and blow through the one going to the IM.

That was the plan! I'm not going to rely on it but I'm curious now because 'Hollywood' on EvoXforums was complaining about his Boomba can blowing up and not getting replaced under warranty. If they are getting pressurized then that would explain it but they have in/out ports on them so there might be a valve there.

[Kracka]

Originally Posted by mlomker

I have exchanged a couple PMs with him. I decided to go with another brand since I found some shiny, bling ones.

LOL I had the set on my IX powdercoated gloss black.