Evo X upgrades

[twack]

cant you just use pliers to bend it back

[mlomker]

Originally Posted by twack

cant you just use pliers to bend it back

I did enough that it appears to be sealing. It just sucks to spend 3 bills on an intake and then scratch the piss out of it bending it back into shape. The good news is that it'll be covered by a filter anyway.

[Murlo26]

Originally Posted by mlomker

I did enough that it appears to be sealing. It just sucks to spend 3 bills on an intake and then scratch the piss out of it bending it back into shape. The good news is that it'll be covered by a filter anyway.

bummer

I know how you feel. I was scared last week when I switched out all my clamps on my IC piping to T-bolts and didn't want to overtighten them and bend the piping. I have seen a few threads of people bending their pipes so I didn't tighten them down super tight. And strangely on the way to MAP...bam UICP popped off, lol.

[t-revzr]

Originally Posted by Murlo26

bummer

I know how you feel. I was scared last week when I switched out all my clamps on my IC piping to T-bolts and didn't want to overtighten them and bend the piping. I have seen a few threads of people bending their pipes so I didn't tighten them down super tight. And strangely on the way to MAP...bam UICP popped off, lol.

Ha Ha I hate when that happens!

[mlomker]

Originally Posted by Murlo26

I was scared last week when I switched out all my clamps on my IC piping to T-bolts and didn't want to overtighten them and bend the piping.

My problem is that I tightened them using a screwdriver and I had the connection at the turbo pop off while I was working on the other end. That wouldn't do, so I took a 1/4" ratchet and gave each one a couple turns, which of course was too much. A fine line, for sure.