|
It's not difficult, just cut out the glass(using a utility knife or a urethane knife).Clean most of the old urethane off the glass and the pinch weld, leaving a thin layer or clean all off and re-primer with urethane primer.Put a new bead of urethane(I like the 3m stuff) around the pinch weld, press in new glass.Check for good seal and your done.Should take around 30-45mins.BTW you'll have to get a new molding($40-$50), which goes on before you press the glass in.
__________________
-Nulli Secundus-
|
Threaded Mode