New product devolopment

[blageo23]

Originally Posted by scheides

Just a thought: Should there be more rubber on the radiator tabs? The stock ones have a bit more give to them don't they? I just worry about the plastic endtanks and the mounting pins (from the radiator itself) cracking from too much vibration.

We are thinking that as well, We are also wondering if the alignment pins in the stock ones will be needed to stop the raitator from shifting. This one was just a prototype to try it out. We will design a different one if these doen work out.

Originally Posted by 95talonracer

Would it be better to cover the front of the CAS as well?

This brings up a good point but they way we look at it is the exhaust manifold is the hottest parts, the radiator hose doesnt get that hot compaired to the exhaust. And closing the CAS in with another side would more then likely trap heat in and around the CAS.

[Kracka]

Originally Posted by blageo23

We are thinking that as well, We are also wondering if the alignment pins in the stock ones will be needed to stop the raitator from shifting. This one was just a prototype to try it out. We will design a different one if these doen work out.

I think utilizing the alignment pins plus a little more rubber would be a good idea. Can't wait to see the final product

[mx3twinturbo]

Thanks for all you input guys!!!