T3 vs. Mitsu housing

[At-Least-It's-An-Evo]

Originally Posted by turbotalon1g

To be exact, I am looking at an HX35 in either a bolt-on .55 a/r or T3 .70 a/r.
Spool in bolt-on is said to be comparable to E316G but top end has been reported 50lb/min+, a friend of mine is seeing 49 lb/min @26psi.

Looks like a HX35 compressor wheel or whatever flows 55-60 lbs a minute is what the general info after googling says. Thats more than that evo16g will flow but I highly doubt it will spool as fast. You know there will always be a trade off for spool vs. more flow... right?

If you hated the sc61 or whatever you had, you'll probably hate the HX35 too.