View Full Version : Project XXX AWD WHP Or Bust!
Pages :
1
2
3
4
5
6
7
[
8]
9
10
11
12
13
14
Alpha D
07-05-2012, 09:51 PM
E85 and plennnty Boost to pass around! People seem to have good succes with 272 wish I could trade someone for my bigger camms :D
x-pride
07-05-2012, 10:12 PM
E85 and plennnty Boost to pass around! People seem to have good succes with 272 wish I could trade someone for my bigger camms :D
272 is the way to go or 264. You put a lot of time and money into your build why take the risk.
If you are running a stock tranny I would not rev past 7200. Stock tranny doesn't play well at higher rpm shifting.
Alpha D
07-05-2012, 11:28 PM
7200 hmmm I guess that would be alright with me...yeah lots of money..not as much as some but enough. Ill just run my stock camms and set the rev limiter to 7500 or 7200 ill ask Shane ...
So shall we play guess that horse power? 26-28psi 50 trim, new 1g pistons and rods, duall 255 rewired fuel pumps, base fp set at 45, 2G maf ...1450cc injectors, e85, fp manifold, PORTED O2 housing, 3inch downpipe bolted on to a straight 3 inch pipe all the way back. Stock intake manifold, ETS core fmic set up 2G Throttle body inlet...my guess is 327 whp no idea about torque 338!
evotuner
07-05-2012, 11:37 PM
336/308
x-pride
07-06-2012, 07:59 AM
My guess 265 to 280 on the heart breaker dyno.
turbotalon1g
07-06-2012, 09:28 AM
I think it will break 300 on there.
Depending on the condition of your transmission will determine how it likes high RPM shifting, just because it is stock doesn't mean it won't do it. I've shifted plenty of stock transmission's above 7500rpm, the clutch is the main point.
You can make a lot of power and high rpm power on a stock trans you just need a clutch.
6 puck/clutchnet disk or twin disk. If I did another manual DSM i'd do this with a stock trans. then 2.0 5858 and make 600whp.
Alpha D
07-06-2012, 09:48 AM
Heart Break for SURE! 280 would be very very very depressing but from my set up i wouldnt be to suprised either...:( ill stick with my NUMBERS though :D
mdost03
07-06-2012, 12:53 PM
Should definitely break 300 on the dyno. Good luck, looks good!
goodhart
07-06-2012, 04:38 PM
Should be close to 300 on pump gas I bet. I guess 350ish if you are only wanting to run 26-28 psi and stock cams?
Halon
07-06-2012, 04:59 PM
I think I made 340 at LSE on my old 50trim setup. Forget the details but it was e85, low 20's for boost, 272's, and a horseshit street tune done on the way to the dyno day.
vBulletin® v3.8.4, Copyright ©2000-2025, Jelsoft Enterprises Ltd.