Log in

View Full Version : Turning my quest into a dsm.


Pages : 1 2 3 4 5 6 7 8 [9] 10 11 12 13 14 15 16 17 18 19 20 21 22

Super Bleeder!!
11-26-2008, 01:13 PM
It certainly cant hurt.

FattyBoomBatty
11-26-2008, 05:32 PM
I'm very scared for your shortblock dude.

Meh, it'll be fine, it's a champ! anyway, I'm not trying for rediculous numbers, and no one has ever really even pushed a mostly stock block.

FattyBoomBatty
11-28-2008, 10:29 PM
lol, thank FSM for simple fixes. The feed line for the turbo has an adaptor and that wasn't tightened down enough. And I figured I'd just let'er buck with the thermostat and all was well, no problems, got up to temp and stayed there. adjusted the idle a little bit, it'll hang around 800-850. Baller. got all the vac lines hooked up and took it for a spin, went and got gas, half a tank for 20 bucks, haha. it's a fun-ass car.

Shotgun!
11-29-2008, 09:27 PM
Make a video!

FattyBoomBatty
11-29-2008, 09:57 PM
I will. belly belly soon.

FattyBoomBatty
02-25-2009, 05:05 PM
http://www.mitsustyle.com/photopost/data/529/medium/DSC02556.JPG

Instead of having a bolt go through the valve cover like it used to, I took advantage of the head being off the car and drilled and tapped a new hole in the back of the head. It goes through to the water passage, but I'm not worried, I sealed it up nice. The bolt is more of a precaution since the CAS is a tight fit anyway. Better safe than sorry, I guess.

scheides
02-25-2009, 05:43 PM
Cool, what's the status of the bottom end?

FattyBoomBatty
02-25-2009, 06:04 PM
Just waiting for the rotating assembly to be balanced, then I get it back. Maybe friday.

Then I just have to buy gaskets, and be sure to put it all back together correctly.

Febo
02-25-2009, 09:25 PM
Yay!

FattyBoomBatty
03-02-2009, 05:43 PM
http://www.mitsustyle.com/photopost/data/529/medium/DSC02559.JPG
http://www.mitsustyle.com/photopost/data/529/medium/DSC02561.JPG

Here we go! 8:1 forged wisecos, shotpeened rods, block was bored with a torqueplate, crank polished and rebalanced. I'm going to start assembly later this week and take my time and do everything right.