MitsuStyle - Viewing Shoutbox Archive

		MitsuStyle > Archive
Viewing Shoutbox Archive

Shouts

07-01-2008 04:10 AM EclipseGST

right, so I go to setup > sensors > knock sensor > knock control and make that map?

07-01-2008 04:09 AM Shane@DBPerformance

you might need 3+ volts 8000 rpms

07-01-2008 04:09 AM Shane@DBPerformance

a 2g knock sensor is picks up all kinds of noises

07-01-2008 04:09 AM Shane@DBPerformance

you need to build the table versus rpm

07-01-2008 04:08 AM EclipseGST

this is the hard part, to find out how to set the knock table and what i want to retart and increase

07-01-2008 04:08 AM EclipseGST

so say I set knock control up for 1v and above it retards timing and gives xxx amount more fuel, would that work or should I actually go through and figure it out.

07-01-2008 04:06 AM Shane@DBPerformance

they like to knock easy

07-01-2008 04:06 AM Shane@DBPerformance

sure, knock is control is good on any dsm

07-01-2008 04:06 AM Shane@DBPerformance

knock #1 tooth shows when a knock happend at a time that makes sense. like a knock should happen right after it fires a cylinder

07-01-2008 04:06 AM EclipseGST

yeah i always log knock #1 volts

Statistics
Total Shouts:	192,056
Shouts In Past 24 Hours:	0
Your Shouts:	0
Top 10 Shouters
A//// Guy	14565
Kracka	13761
Speedfreak	10303
asshanson	9965
EclipseGST	9066
HiImBrian	8141
DSM_421	7604
Super Bleeder!!	7135
User Name	7080
AJ	6569