idle changes when pressing clutch

[viridionplague]

thought i would update this since i lost motivation and just got to checking the play in the crank.

pretty sure ive got crankwalk. came up with .012 for shaft endplay. if i remember correctly is supposed to be between .006 and .008? been looking for the spec online for 10 minutes and havnt found it yet

[4*G*6*3]

Originally Posted by viridionplague

thought i would update this since i lost motivation and just got to checking the play in the crank.

pretty sure ive got crankwalk. came up with .012 for shaft endplay. if i remember correctly is supposed to be between .006 and .008? been looking for the spec online for 10 minutes and havnt found it yet

.002" -.007" or .05mm -.18mm

heres a helpful video for measuring correctly.

http://www.youtube.com/watch?v=229xUQZSFLE

[niterydr]

Originally Posted by viridionplague

thought i would update this since i lost motivation and just got to checking the play in the crank.

pretty sure ive got crankwalk. came up with .012 for shaft endplay. if i remember correctly is supposed to be between .006 and .008? been looking for the spec online for 10 minutes and havnt found it yet

Did you measure off the crank or end pully? If end pully, remove and re-measure, there is some give on the rubber on the stock dampener.