Had a few free minutes tonight. So I went out to the garage, cracked open a Coors, cranked up the heat, threw the dog a bone, and got to work.
I decided to take on the mind numbing process of getting that structural piece out from between the rear strut towers. For those who don't know, its just a piss ton of spot welds holding this on, about half of which you can't get a spot weld cutter on. It's a terribly slow process....
Little bit by little bit its getting done. (Sorry about the crappy picture quality on the last 2, not really sure what happened there)
Also finally got my hydraulic rams for the rotisserie I'm building.
Threaded Mode