Bent valves? or Droped a valve, Pictures inside!

[1999Gst]

lol yea idk i got it and it needed a flywheel/clutch, did that 2 months later this. So should i put the 200-300 into it for a new headgasket arps and gaskets,even though the pistons have a little valve marks where they hit, or just grab a 6 bolt? even tho im low on funds.

[Perkul8r]

The little marks on the pistons are fine. You can clean them up a little and run it. My Laser had some pretty good marks on the pistons and I just cleaned them up, put new head on and ran it. No need to swap out the motor if everything else is fine.