WTB: 1g dsm parts

[GREASEMONKEY]

Originally Posted by acidrumz

iirc, you will need a 91+ tranny/transfer case to mate with the 91+ driveshaft because of the spline count of the tc.

Im pretty sure that the spline count on the driveshafts are all the same 90 - 94.

If you have a 1990 Tranny & X-Case and you want to switch over to a 91+ setup you will need to change your tranny and X-case but the driveshafts are the same 90-94.

I dont know if i misread your post or not but hopefully that clears up the confusion.

-Stephan

[acidrumz]

Originally Posted by GREASEMONKEY

Im pretty sure that the spline count on the driveshafts are all the same 90 - 94.

If you have a 1990 Tranny & X-Case and you want to switch over to a 91+ setup you will need to change your tranny and X-case but the driveshafts are the same 90-94.

I dont know if i misread your post or not but hopefully that clears up the confusion.

-Stephan

ok it must have been just the tc that has the different spline counts per 90/91+
thanks for clarification, so to the op, yes the driveshaft would fit.

[93tsiawd]

ok i found a awd driveshaft out of a 93 n i also found a 91 awd tranny but i dnt thnk the transfer case is included