|
Engine Harness Repair
So I recently swapped a new engine into my Mazda and now it's dead again. I discovered that the part of the wiring harness that goes to the injectors, crank sensor, and emissions valves, etc, is melted through. I apparently routed it over a hot exhaust part to the intake manifold and it finally broke now.
The question is, can I just cut the wires back, get some butt connectors and wire and connect it all up? And then the obvious of insulating it and sleeving it back up.
I've done this with other shit, JW if this can be held true with a engine wiring harness. I can't afford 850$ from Mazda for a new one.
__________________
Need computer help? PM me if you need repair/virus problems/system building/etc, virtually anything.
"...when u lube up the pistons ur supposed to get higher compression then when they are dry..."
|
Threaded Mode