Fuel Pump Issue

[Gravy]

I don't have access to another sending unit, but i know the ground from the factory does work, and i have a secondary ground going to the frame of the sending unit as well.

I did the rewire by the book, and it will run now both in stock format, and with the rewire on there. And with the rewire on if i hook up a stock mass i still get the same issues when it acts up, and works both ways when the problem presents itself. I run with a GM maf and when i start it with the stock hooked up, with out metering the air, the relay clicks on and off like it should. When the car is running with only the three bolts holding it down, i can let it idle, rev it up, and it runs just fine. And it would technically work if i didn't mind the smell of gas following me everywhere.