|
Re: My Talon
I picked up my TurboX coated parts from Bob at Map today. I went over to the car and put some of it on. I realized I'm gonna have to cut a lot more off my downpipe than I thought, and I need to chop part of my compressor cover outlet off and weld on a 90 elbow.
The drain is gonna be kinda funky. I might need two 45 degree -10 fittings to get it to work right.
I also need some more 02 housing bolts, I should most likely order new turbo bolts and lock washers from mitsu.
I have to fab up my 4" intake, v band downpipe, a oil drain, install cams and new OFH and oil cooler, and set up Link!
__________________
Misses the Mitsu Community
Currently on Corvette #4
Last edited by sleepydsm; 03-07-2009 at 07:52 PM..
|
Threaded Mode