Clutch hydraulic system

[iceminion]

Thank you Andrew for your suggestion, and yes, it is adjusted all the way out, anymore and the u-shaped nut would fall off the end.

dragonforce - on post #1 and #4 I said that I checked for play, but thank you for the write-up...I did it a different way, I got upside down, stuck my head where your toes go, and wiggled the pedal with one hand and looked at the other side of the assembly with a flashlight, about .5mm of play due to the peg diameter vs. hole diameter.

[Andrew7dg]

Originally Posted by iceminion

Thank you Andrew for your suggestion, and yes, it is adjusted all the way out, anymore and the u-shaped nut would fall off the end.

Making sure once again because it sounded like you missed a step...

You can take the nut off of that rod and twist the rod. With your hand. The rod will back out of the master cylinder to give you more play. Just make sure that it doesn't fall out of the master cylinder. Once the rod has been twisted out a couple of turns, put the nut back on.