Here are more pictures...
http://www.vasso.net/jake/
The car is AWD... Fully built motor and everything is supported. Its running good but having a little problem with the tune so I might not race tomorrow but I will still go to the track.
Also, the turbo is not a 42r. It is similar but not entirely the same. It has a smaller exhaust wheel and close to the same size compressor wheel in one of the models, yet it still uses the same compressor housing. It has a P-Trim exhaust wheel with a .68A/R turbine housing and a 72mm compressor wheel. I just am completely amazed that it fit so well. The turbo is so massive yet it clears everything.
I had to make 2 modifications, grind a little off the bracing on the DNP manifold and cut a little out of the cross member for the lower IC piping to attach to the turbo. Other than that it fits perfect. Oh and dent the water pipe slightly. Not very much at all. Spools good and pulls very hard. I'm impressed with it.
Threaded Mode