Check out this 4g63 rebuild

Pimpin Dsmstyle · 10-24-2005

I think it's something more along the lines of he worked with someone that was a freak about building motors. Granted, I think that's part of his job now, but I doubt he's built 100's of motors or anywhere close.

Alot of the points he showed was common sense things. That and he was rebuilding a 7 bolt, no point - waste of time. With those 2 problems, that was most of his errors on the assembly.

AJ · 10-24-2005

Quote:

Originally Posted by Pimpin Dsmstyle

I think it's something more along the lines of he worked with someone that was a freak about building motors. Granted, I think that's part of his job now, but I doubt he's built 100's of motors or anywhere close.

Alot of the points he showed was common sense things. That and he was rebuilding a 7 bolt, no point - waste of time. With those 2 problems, that was most of his errors on the assembly.

Oh he put together his fair share at QPR. Mike did the quality control and specs verifying, but Josh had his hands in them.