Quote:
Originally posted by SlowWhite@Oct 27 2004, 09:09 AM
I'm keeping my 2G Head with my Car. Which is why I asked about the Cam gears?
OFF topic:
What do you have to change with there being no Crank Angle Sensor on a 6 bolt 2.4L block?
|
You have to wire up a 1g CAS to take the place of both the 2g CAS and 2g crank position sensor.
RRE has a couple methods of wiring this but by far the easiest is to buy their ready made harness. You will also need to swap plug wires and injector pin outs at the harness on the ecu. Again, all of this is described in detail on RRE's site.
Jim
Threaded Mode