My "new" car/project.

[bramagedained]

I had use of a rivetnut kit over the weekend so I have the 3 distribution blocks and the fuse/relay panel mounted.

I wired up the hazard switch and blower motor.

I slightly changed the plumbing of the vents, it now will only blow out the center. The way it was the blower just didnt move enough air to come out the center and both sides(there was otherwise no way to block off any of the vents). I'd rather have it be stronger from one spot than weak from all of them.

The temporary wiring to get it started was cleaned up.

Autometer water temp and oil pressure sensors installed and wired up.

I now have the wiring for the wipers sorted. There will no longer be an intermittent setting, only Off-Low-High.