30-31" FMIC will fit fine on a 2g. You probably wont need to take out the bumper beam across the front seeing its only 7" high. You will need to shave quite a bit off the back of the bumper cover to get it to go back on right but nothing major. My FMIC is 30.5x12x3.5 and all I had to do is remove the bumper beam and cut the bumper cover a little. Really wasnt all that big of a deal. Short route piping was easy to fab up and everything went together good. Shouldnt be too difficult for you. Good luck with it.
Quote:
|
Originally Posted by howslowcanyougo
Just gotta figure out how to properly block off those water lines now?
|
Whenever Mike gets out of the hospital you might want to talk to him about welding them shut for ya. If your a good welder or know someone that is then that would work too.
Threaded Mode