Anna was immersed in a book last night after we got back from Wagner's. I had a rom to test for a certain someone so I spent a bit copying tables over and then went out to the garage to load it on the car. I decided I should yank the front motor mount quick. I talked to AMS about getting a softer mount insert, and they suggested drilling some holes in the existing one (which is what I was considering in the first place). Six 3/8" holes:
Five minutes after jacking the car up, I had this:
Upon further review, I think I'm going to enlarge the top/bottom holes to 1/2", and add another 3/8" hole on either side f/r, for a total of 6x 3/8" holes and 2x 1/2" holes. This should provide plenty of stiffness over the stock bushing, but not rattle my head when idling.
Also, while I was on the ground, I happened to look up, at the bottom of the FMIC core, and look what I saw:
So, the FMIC is actually a Garrett/PTE core. 051-1124, specs are: 3" x 18" x 12"
Just nice to know exactly what I have now, instead of guessing.
The ROM checked out so watch for a post from our friend Tephra soon
I will be pulling off the trunklid tonight and dropping it off tomorrow to have the holes filled! The rest of the car goes in for PDR, fill the nasty fender gash, paint, and detailing next week. Yay!
Threaded Mode