Finally getting stuff done on our cars

[Goat Blower]

Originally Posted by Jakey

If I were you, I'd get a 100% stock housing and send it off to Advanced Design Concepts to get a CAD model made. It is nearly impossible to 100% reverse engineer a piece like this without some sort of laser scan or touch probe because of all the fine details. By having a CAD model, you could have someone run an FEA simulation on the piece to determine where the stress concentrations are and then be able to specifically target your reinforcements.

Or you could just weld reinforcements and call it good. Some of y'all over complicate this stuff.