So if you have been to Primo in the past couple months you may have seen my car a 1941 chevy 2 door sedan. I wanted to do something different and since I grew up working on street rods I started with this car but instead of putting in a 350/th350 for the drive train like everyone else out there I went with 4g63/t-56. It should be interesting to see peoples reactions. I've been slowly working on it and thought I would start a project thread. So far the chassis has a mustang 2 kit for the front suspension, and a rear end from a s-10. The short block has Eagle rods Wiseco pistons, and head is stock so far. I will be making custom intake and exhaust manifolds to fit the engine bay. so here we go...
So this is what the car looked like when I bought it
dismantling!
repairing the floors and rockers
The frame ready for powder coating
the frame fully powder coated along with all the suspension
the t-56 with a custom bellhousing made by Bill Hincher
mock engine mated up to the t-56
Engine and tranny bolted in
engine bay mocked up
tranny fitted inside
Next step is to find a day that I have off that is nice weather wise so i can roll the body outside and sandblast it.
Threaded Mode