Quick Speed denisty conversion question.

[Perkul8r]

So after having some little problems with my car, i have it running again. Only to find out my maf is not good. Now, i have a friend that wrecked his car and is selling his speed density harness and sensors for cheap. Now all the searching i have done talks about people using the setup with some sort of tuning. And i was just wondering if you can run it on a stock ECU. I am saving up some money to buy a dsm link. So i will have some sort of data logging in the hopefully near future. Just kinda wanna get the car back on the road. Thanks.

[scheides]

just replace the MAF, get it running good, THEN look at SD. Otherwise you'll just be compounding your problems.

Shane @DB can tune you on SD on the stock ecu w/ a chip flash, give him a call.

[turbotalon1g]

^Really? Thanks for that info.

[Perkul8r]

Cool. I will probably still pickup the speed density stuff just to have it. And i gotta start looking for a new MAF. I think the guy that bought my parts car might have an extra one. I was hoping that I could take my car tomorrow but it will have to wait.

I still need to find out if my ecu is an eprom or not. I did find a guy selling an eprom ecu and dsm link v 2.5(not 100% sure on the version) For like $425. It sounds like a good deal, but i dont know much about pricing on these.

Thanks.

[turbotalon1g]

Link dropped their prices recently down tto $495 new I believe. Depending on what you want to do I would try and get the extra money to get V3.

[Perkul8r]

Well, i would like to do alot of things. lol. Just money holds me back. right now i am just trying to replace things that are worn out, like the stock intercooler hoses. I think they might be leaking, I haven't had time to make a boost leak tester. They are cracked to hell. Oh well.