MitsuStyle

MitsuStyle (http://www.mitsustyle.com/forums/index.php)
-   Tuning/Electrical (http://www.mitsustyle.com/forums/forumdisplay.php?f=90)
-   -   Quick Speed denisty conversion question. (http://www.mitsustyle.com/forums/showthread.php?t=27519)

Perkul8r 08-09-2010 10:56 PM

Quick Speed denisty conversion question.
 
So after having some little problems with my car, i have it running again. Only to find out my maf is not good. Now, i have a friend that wrecked his car and is selling his speed density harness and sensors for cheap. Now all the searching i have done talks about people using the setup with some sort of tuning. And i was just wondering if you can run it on a stock ECU. I am saving up some money to buy a dsm link. So i will have some sort of data logging in the hopefully near future. Just kinda wanna get the car back on the road. Thanks.

scheides 08-10-2010 09:02 AM

Re: Quick Speed denisty conversion question.
 
just replace the MAF, get it running good, THEN look at SD. Otherwise you'll just be compounding your problems.

Shane @DB can tune you on SD on the stock ecu w/ a chip flash, give him a call.

turbotalon1g 08-10-2010 11:51 AM

Re: Quick Speed denisty conversion question.
 
^Really? Thanks for that info.

Perkul8r 08-10-2010 04:51 PM

Re: Quick Speed denisty conversion question.
 
Cool. I will probably still pickup the speed density stuff just to have it. And i gotta start looking for a new MAF. I think the guy that bought my parts car might have an extra one. I was hoping that I could take my car tomorrow but it will have to wait.

I still need to find out if my ecu is an eprom or not. I did find a guy selling an eprom ecu and dsm link v 2.5(not 100% sure on the version) For like $425. It sounds like a good deal, but i dont know much about pricing on these.

Thanks.

turbotalon1g 08-10-2010 08:24 PM

Re: Quick Speed denisty conversion question.
 
Link dropped their prices recently down tto $495 new I believe. Depending on what you want to do I would try and get the extra money to get V3.

Perkul8r 08-10-2010 09:34 PM

Re: Quick Speed denisty conversion question.
 
Well, i would like to do alot of things. lol. Just money holds me back. right now i am just trying to replace things that are worn out, like the stock intercooler hoses. I think they might be leaking, I haven't had time to make a boost leak tester. They are cracked to hell. Oh well.


All times are GMT -5. The time now is 10:00 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.