Not sure if this is the right forum to post this in but...
For those who haven't already heard of or seen this thread on RMDSM
http://www.rmdsm.org/forums/showthread.php...p?threadid=2464 and
http://206.124.12.138/manifolds/index.html
They have done a dyno test on most of the popular aftermarket intakes available and will be posting the results by the end of this week. They even had a couple stock extrude honed intakes to test in addition to all the sheet metal/cast intakes.
Should be interesting to read once they post the results.
Jim
Threaded Mode